Huawei OceanStor S2600 - System Management Commands; Table 2-3 System Management Command Set

Classification Command
Batch processing command autobat
Commands of setting the IP address of the
management network interface on the
controller
chgctrlip
showctrlip
CLI idle time setting command chgidletime
2.2.2 System Management Commands
The system management commands are mainly used to configure and query the running
information of the storage system.
Table 2-3 lists the system management commands.
Table 2-3 System management command set
Classification Command
System information query commands showsys
showsysfail
showtemperature
showvoltage
showsn
showlicense
Controller management commands offline
showctrlinfo
Alarm log exporting or log exporting
commands
exportalm
Configuration management commands exportcofferdb
exportblackbox
exportconf
importconf
exportstat
Statistics management commands showstatswitch
chgstatswitch
statperf
statres
OceanStor S2600 Storage System
Command Reference 2 Introduction to the CLI Commands
Issue 07 (2010-05-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-5