Parameters
Keyword and Value Description Default Value
-i HyperImage ID
The HyperImage ID. The value ranges from 0 to
127.
You can query the information by running the
showhyimginfo command.
None.
-l speed level
The rollback rate. The value ranges from 1 to 4.
l 1 stands for low.
l 2 stands for middle.
l 3 stands for high.
l 4 stands for ASAP.
None.
Modes
Normal mode.
Level
Super administrator level and administrator level.
Usage Guidelines
The command is used only when the HyperImage is in the rollback state.
Example
Set rollback speed of the HyperImage with the ID of 19 to low.
OceanStor: admin> chghyimgrollbackspeed -i 19 -l 1
The command has been sent, please wait...
System Response
None.
9.1.19 createtimehyimg
Function
The command createtimehyimg is used to create a HyperImage according to the source LUN
at a specified point-in-time and time interval.
Format
createtimehyimg {-i source LUN ID...} -n nums -st start time -ti time interval
9 Value-Added Service Management Commands
OceanStor S2600 Storage System
Command Reference
9-20 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 07 (2010-05-20)
To Next Page
Loading...
