Huawei OceanStor S2600 - Connecttgt; Chgtgt

9.4.3 connecttgt
Function
The command connecttgt is used to connect a specified initiator to a target (controller).
Format
connecttgt -c controller ID -ti target ID
Parameters
Keyword and Value Description Default Value
-c controller ID
The controller ID. The value is A or B, and it is case
insensitive.
None.
-ti target ID
The target ID. The value ranges from 0 to 7.
None.
Modes
Normal mode.
Level
Super administrator level and administrator level.
Usage Guidelines
None.
Example
Connect to the target with the ID of 1 on controller A.
OceanStor: admin> connecttgt -c a -ti 1
System Response
When the command is complete, you can run the showtgt command to view the result.
9.4.4 chgtgt
Function
The command chgtgt is used to modify configurations of the initiator added to a target
(controller).
OceanStor S2600 Storage System
Command Reference 9 Value-Added Service Management Commands
Issue 07 (2010-05-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9-53