Huawei OceanStor S2600 - Deletehycplun

System Response
None.
9.2.4 deletehycplun
Function
The command deletehycplun is used to delete the target LUN of a HyperCopy.
Format
deletehycplun -i HyperCopy ID -ti target LUN ID
Parameters
Keyword and Value Description Default Value
-i HyperCopy ID
The HyperCopy ID. The value ranges from 0 to 63.
You can query the information by running the
showhycpinfo command.
None.
-ti target LUN ID
The target LUN ID.
When the LUN is "internal LUN", the value ranges
from o to 511. When the LUN is "external LUN" or
"third-part LUN", the value ranges from 100000 to
101023.
You can query the information by running the
showhycpluninfo command.
None.
Modes
Normal mode.
Level
Super administrator level and administrator level.
Usage Guidelines
l Before deleting, you can run the showhycpluninfo command to query the correct target
LUN ID, thus preventing deletion by mistake.
l Failure of a certain target LUN might cause fault of the HyperCopy task. When the failed
target LUN is deleted, the HyperCopy task is started automatically.
Example
Delete the target LUN with the ID of 0 of the HyperCopy with the ID of 0.
9 Value-Added Service Management Commands
OceanStor S2600 Storage System
Command Reference
9-34 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 07 (2010-05-20)