Huawei OceanStor S2600 - Showfcmode

Keyword and Value Description Default Value
-p Port ID The ID of an iSCSI host port.
The value ranges from 0 to 3.
l S2600i: Each host port
module is configured with
four iSCSI host ports.
From left to right, the host
ports are numbered 0, 1, 2,
and 3 in sequence.
l S2600C: Each host port
module is configured with
two FC host ports and two
iSCSI host ports. From left
to right, the iSCSI host
ports are numbered 0 and
1 in sequence.
None.
Modes
Normal mode.
Level
Super administrator level, administrator level and guest level.
Usage Guidelines
The command showiscsiroute is used to query the routing configurations information about an
iSCSI host port.
NOTE
The command is only applicable to iSCSI host ports on the controller of the storage device.
Example
On controller A, query the configurations of iSCSI host port with ID 1.
OceanStor: admin> showiscsiroute -c a -p 1
Controller Port ID Dest IP Subnet Mask Gateway
A 1 192.12.5.0 255.255.255.0 192.168.200.1
5.13.9 showfcmode
Function
The command showfcmode is used to query the topology of the current FC port.
5 Device Management Commands
OceanStor S2600 Storage System
Command Reference
5-34 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 07 (2010-05-20)