Huawei OceanStor S2600 - Expander Module Management Command

Modes
Normal mode.
Level
Super administrator level, administrator level and guest level.
Usage Guidelines
When using this command, note the following items:
l The command showinterface is used to query the information about all host port modules
in the system.
l The command showinterface -c controller ID is used to query the information about all
host port modules on a specified controller.
l The command showinterface -c controller ID -i interface ID is used to query the
information about a specified host port module on a controller.
Example
Query the information about all host port modules in the system.
OceanStor: admin> showinterface
Controller Interface ID Type Status Port0 Port1
Port2 Port3 PCBVer
A 0 4*FC online Connected Connected Connected
Connected STE1FCHA VER.B
Electronic Label:
[Board Properties]
BoardType=STE1FCHA
BarCode=02G055Z094000017
Item=0302G055
Description=FC Host Interface Card
Manufactured=2009-04-24
VendorName=Huawei
IssueNumber=00
CLEIcode=
BOM=
B 0 4*FC online Connected Connected Connected
Not connected STE1FCHA VER.B
Electronic Label:
[Board Properties]
BoardType=STE1FCHA
BarCode=02G055Z094000038
Item=0302G055
Description=FC Host Interface Card
Manufactured=2009-04-24
VendorName=Huawei
IssueNumber=00
CLEIcode=
BOM=
5.6 Expander Module Management Command
Expander module management command is used to manage the expander module.
5.6.1 showexpboard
5 Device Management Commands
OceanStor S2600 Storage System
Command Reference
5-14 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 07 (2010-05-20)