Huawei OceanStor S2600 - Page 122

Keyword and Value Description Default Value
-p Port ID The iSCSI host port ID. The
value ranges from 0 to 3.
l S2600i: Each host port
module is configured with
four iSCSI host ports.
From left to right, the host
ports are numbered 0, 1, 2,
and 3 in sequence.
l S2600C: Each host port
module is configured with
two FC host ports and two
iSCSI host ports. From left
to right, the iSCSI host
ports are numbered 0 and
1 in sequence.
None.
-a IP address The IP address of an iSCSI
host port.
None.
-s subnet mask The subnet mask. None.
-m config mode The configuration mode. The
value can be 2 or 3 and is
described as follows:
l 2: The Trunk mode.
l 3: The normal mode.
None.
Modes
Normal mode.
Level
Super administrator level and administrator level.
Usage Guidelines
The IP addresses of iSCSI host ports and that of the management network interface cannot be
on the same network segment.
NOTE
The command is only applicable to iSCSI host ports on the controller of the storage device.
Example
On controller A , change the IP address of iSCSI host port 1 to 10.10.10.2, and the subnet mask
to 255.255.255.0.
OceanStor: admin> chgiscsiip -c a -p 1 -a 10.10.10.2 -s 255.255.255.0 -m 3
5 Device Management Commands
OceanStor S2600 Storage System
Command Reference
5-30 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 07 (2010-05-20)