Huawei quidway s7700 - Page 109

if HostA needs to receive the multicast data from the multicast group 225.1.1.1 for a long time,
you need to add GE 1/0/0 on the SwitchA to the multicast group 225.1.1.1 statically.
Figure 4-1 Networking diagram for configuring basic IGMP functions
SwitchA
PIM
network
Ethernet
HostA
Receiver
HostB
N1
Leaf
network
HostC
HostD
N2
Ethernet
SwitchB
SwitchC
GE2/0/0
GE2/0/0
GE2/0/0
GE1/0/0
GE1/0/0
GE1/0/0
Receiver
Switch Physical interface VLANIF interface IP address
SwitchA GE 1/0/0 VLANIF 10 10.110.1.1/24
GE 2/0/0 VLANIF 11 192.168.1.1/24
SwitchB GE 1/0/0 VLANIF 20 10.110.2.1/24
GE 2/0/0 VLANIF 21 192.168.2.1/24
SwitchC GE 1/0/0 VLANIF 30 10.110.3.1/24
GE 2/0/0 VLANIF 31 192.168.3.1/24
Configuration Roadmap
The configuration roadmap is as follows:
1. Enable multicast on all Switches providing multicast services.
2. Enable PIM-SM on all the interfaces on Switch.
3. Enable IGMP on the interfaces on the host side.
4. Add VLANIF 10 on SwitchA to the multicast group 225.1.1.1 statically.
Data Preparation
To complete the configuration, you need the following data:
l Version of IGMP running between Switches and hosts
l Static multicast group address: 225.1.1.1
NOTE
This configuration example describes only the commands used to configure IGMP.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 4 IGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
90