Huawei quidway s7700 - Optional) Setting the Aging Time of the Router Interface

l 11.3 Enabling MLD Snooping
Data Preparation
To modify parameters of MLD snooping, you need the following data.
No. Procedure
1 ID of the VLAN where you need to optimize
the performance of MLD snooping
2 (Optional) Aging time of the router interface
3 (Optional) Interval for sending Last Member
Query messages
4 (Optional) Interval for sending the General
Query messages
5 (Optional) Maximum response time of MLD
messages
6 (Optional) Robustness variable of the MLD
7 (Optional) Source IPv6 address of the MLD
General Query message that the MLD
snooping module sends to respond to the
change of the Layer 2 network topology
8 (Optional) Version of MLD messages that the
MLD snooping module can process in the
VLAN
9 (Optional) Duration for suppressing the same
MLD messages
10 (Optional) Number of MLD snooping entries
that can be configured or learned
11.7.2 (Optional) Setting the Aging Time of the Router Interface
Context
To set the aging time of the router interface, do as follows on the S7700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
399