l Run the debugging msdp [ vpn-instance vpn-instance-name | all-instance ] event
command in the user view to enable the debugging of MSDP events.
l Run the debugging msdp [ vpn-instance vpn-instance-name | all-instance ] packet
command in the user view to enable the debugging of MSDP packets.
l Run the debugging msdp [ vpn-instance vpn-instance-name | all-instance ] source-
active command in the user view to enable the debugging of MSDP active sources.
----End
7.12 Configuration Examples
Configuration examples are provided to show how to implement PIM-SM inter-domain
multicast through MBGP, how to implement inter-AS multicast through static RPF peers, and
how to configure anycast RP in a PIM-SM domain.
7.12.1 Example for Configuring Basic MSDP Functions
Networking Requirements
As shown in Figure 7-1, two ASs exist on the network. Each AS contains one or more PIM-SM
domains; each PIM-SM domain has 0 or 1 multicast source and receiver. The receivers in PIM-
SM2 need to receive the multicast data sent by S3 in the PIM-SM3 domain and multicast data
sent by S1 in the PIM-SM1 domain.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 7 MSDP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
260
To Next Page
Loading...
