Huawei quidway s7700 - Maintaining Layer 2 Multicast; Clearing Static Entries in a Multicast Forwarding Table

Procedure
l Run the display igmp-snooping port-info command to view the IGMP snooping entries
on an interface.
----End
Example
Run the display igmp-snooping port-info command, and you can view the IGMP snooping
entries on the interface. For example:
<Quidway> display igmp-snooping port-info vlan 10
-----------------------------------------------------------------------
(Source, Group) Port Flag
Flag: S:Static D:Dynamic M: Ssm-mapping
-----------------------------------------------------------------------
VLAN 10, 3 Entry(s)
(*, 225.1.1.1) GE1/0/2 --M
1 port(s)
(*, 225.1.1.2) GE1/0/2 --M
1 port(s)
(*, 225.1.1.3) GE1/0/2 --M
1 port(s)
-----------------------------------------------------------------------
2.8 Maintaining Layer 2 Multicast
Maintaining Layer 2 multicast involves resetting Layer 2 Multicast statistics, and debugging
IGMP Snooping.
2.8.1 Clearing Static Entries in a Multicast Forwarding Table
Context
CAUTION
Static entries in a forwarding table cannot be restored after you clear them and you have to
configure them again. Confirm the operation before you run the following command.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 2 IGMP Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
40