Huawei quidway s7700 - Configuring Share-Group and Binding an MTI

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Step 3 Run:
service type multicast-tunnel
The Eth-Trunk is configured as a multicast loopback interface.
This command does not take effect if the Eth-Trunk contains member interfaces or other services
are configured on the Eth-Trunk. In addition, this command can run on only one Eth-Trunk of
a device.
Step 4 Run:
trunkport interface-type interface-number
A physical port is added to the Eth-Trunk.
The member interfaces in the Eth-Trunk must support the multicast tunnel service.
An Eth-Trunk set up between boards cannot be configured as a multicast loopback interface.
----End
8.3.4 Configuring Share-Group and Binding an MTI
When configuring the IPv4 multicast VPN, you need to configure a share-group address and the
MTI to be bound to the VPN instance. On one PE, different VPN instances cannot have the same
share-group address.
Context
Do as follows on the PE switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip vpn-instance vpn-instance-name
The VPN instance view is displayed.
Step 3 Run:
multicast-domain share-group group-address binding mtunnel number
A share group is configured. The system automatically creates an MTI, and then binds the share
group to the MTI and binds the MTI to the VPN instance.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 8 IPv4 Multicast VPN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
288