Huawei quidway s7700 - Configuring Filtering Rules Based on Source Addresses

Context
Do as follows on the PIM-IPv6 switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
source-lifetime interval
The Keepalive period of a source is configured.
When the Keepalive period expires, the (S, G) entry becomes invalid.
----End
13.4.3 Configuring Filtering Rules Based on Source Addresses
After ACL6 rules are configured, a multicast device can filter the received multicast packets
based on source addresses or source/group addresses.
Context
Do as follows on the PIM-IPv6 switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
source-policy { acl6-number | acl6-name acl6-name }
A filter is configured.
If the basic ACL is configured, only the packets with the source addresses that pass the filtering
are forwarded.
If the advanced ACL is configured, only the packets with the source addresses and group
addresses that pass the filtering are forwarded.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 13 PIM-SM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
463