Huawei quidway s7700 - Optional) Configuring the MLD Version; Optional) Configuring an Interface to Statically Join a Group

interface-type interface-number specifies the interface connected to hosts.
Step 3 Run:
mld enable
MLD is enabled on the interface.
By default, MLD is not enabled on the interface.
----End
10.3.4 (Optional) Configuring the MLD Version
You need to configure the version of MLD enabled on the interface of a multicast device
connected with the user network segment. Note that the versions of MLD enabled on the
multicast devices on the same network segment should be the same; otherwise, a network
abnormality occurs.
Context
CAUTION
Ensure that all MLD switch interfaces in the same network segment are configured with the
same MLD version. Otherwise, faults may occur.
This configuration is optional. By default, MLDv1 is adopted.
Do as follows on the switch connected to hosts:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
Step 3 Run:
mld version { 1 | 2 }
The MLD version of the interface level is configured.
By default, MLDv1 is adopted.
----End
10.3.5 (Optional) Configuring an Interface to Statically Join a Group
After a static MLD group is configured on the interface that connects a multicast device to the
user network segment, the multicast device considers that the interface has multicast group
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 10 MLD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
360