Huawei quidway s7700 - Configuring Filtering Rules Based on Source Addresses

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
source-lifetime interval
The Keepalive period of a source is configured.
If a switch does not receive any (S, G) packet in the Keepalive period of the source, the
switch considers that the source stops sending multicast data to G, and the (S, G) entry becomes
invalid.
----End
12.4.3 Configuring Filtering Rules Based on Source Addresses
After ACL6 rules are configured, a multicast device can filter the received multicast packets
based on source addresses or source/group addresses.
Context
Do as follows on the PIM-IPv6 switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
source-policy { acl6-number | acl6-name acl6-name }
A filter is configured.
The nearer the filter to the source, the more obvious the effect of the filtering.
If the basic ACL is configured, only the packets with the source addresses that pass the filtering
are forwarded.
If the advanced ACL is configured, only the packets with the source addresses and group
addresses that pass the filtering are forwarded.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 12 PIM-DM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
422