Huawei quidway s7700 - Configuring PIM Neighbor Filtering; Checking the Configuration

Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
pim ipv6 require-genid
The Generation ID option is set in a Hello message.
The Hello message without the Generation ID option is rejected.
----End
12.5.5 Configuring PIM Neighbor Filtering
To prevent some unknown devices from being involved in PIM, filtering PIM neighbors is
required. An interface sets up neighbor relationships with only the addresses matching the
filtering rules and deletes the neighbors unmatched with the filtering rules.
Context
To prevent some switch from being involved in PIM, filtering PIM neighbors is required.
Do as follows on the switch running IPv6 PIM-DM:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
pim ipv6 neighbor-policy { basic-acl6-number | acl6-name acl6-name }
PIM neighbor filtering is configured.
An interface sets up neighbor relationships with only the addresses matching the filtering rules
and deletes the neighbors unmatching the filtering rules.
NOTE
When configuring the neighbor filtering function on the interface, you must also configure the neighbor
filtering function correspondingly on the switch that sets up the neighbor relationship with the interface.
----End
12.5.6 Checking the Configuration
After the neighbor control parameters are adjusted, you can run commands to check information
about the PIM interface and the PIM neighbor.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 12 PIM-DM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
427