EasyManua.ls Logo

Huawei quidway s7700 - Topology

Huawei quidway s7700
551 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Enable MLD snooping in VLAN 3 on all the S7700s.
5. Enable the MLD snooping module of SwitchA to respond to changes of the Layer 2 network
topology.
Data Preparation
To complete the configuration, you need the following data:
l Source IP address contained in the MLD General Query message that the MLD snooping
module sends to respond to changes of the Layer 2 network: FE80::1
Procedure
Step 1 Enable MSTP on all the S7700s. The configuration procedure is not provided here. For the
method of configuring MSTP, see the Quidway S7700 Smart Routing Switch Configuration
Guide - Ethernet.
Step 2 Create VLAN 3 and add interfaces to VLAN 3 on all the S7700s. The configuration procedure
is not provided here.
Step 3 Run the mld-snooping enable command to enable MLD snooping globally on all the S7700s.
Step 4 Enable MLD snooping in VLAN 3 on all the S7700s.
[SwitchA] vlan 3
[SwitchA-vlan3] mld-snooping enable
[SwitchA-vlan3] quit
The configurations of other S7700s are similar to the configuration of SwitchA, and are not
provided here.
Step 5 Enable the MLD snooping module of SwitchA to respond to changes of the Layer 2 network
topology.
[SwitchA]mld-snooping send-query enable
[SwitchA] mld-snooping send-query source-address FE80::1
Step 6 Verify the configuration.
l Verify that Host 1 and Host 2 can receive multicast data.
l Run the display stp command on the S7700s to find the interfaces that are blocked and the
transmission path of multicast data.
l Assume that GE 1/0/1 is blocked and multicast data is transmitted to Host 1 through the path
SwitchA -> SwitchC -> SwitchB and to Host 2 through the path SwitchA -> SwitchD. Run
the shutdown command on GE 1/0/1 of SwitchC to shut down the interface so that the
topology of the MSTP network changes.
l Verify that Host 1 and Host 2 can still receive multicast data after the network topology
changes.
----End
Configuration Files
Configuration file of SwitchA
#
sysname SwitchA
#
mld-snooping enable
mld-snooping send-query enable
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
412

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals