Huawei quidway s7700 - Configuring the Igmpv1 Querier

1. Run:
system-view
The system view is displayed.
2. Run:
igmp
The IGMP view is displayed.
3. Run:
require-router-alert
The S7700 is configured to ignore the IGMP messages that do not contain the Router-
Alert option.
4. Run:
send-router-alert
The S7700 is configured to add the Router-Alert option to the IGMP message header.
NOTE
After you run the send-router-alert command, information about the Router-Alert option will
not be displayed when you view the current configuration. To view information about the
Router-Alert option, run the undo send-router-alert command first.
l Configuring IGMP message options for the interface
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
The S7700 uses this interface to communicate with hosts. On the S7700, VLANIF
interfaces and loopback interfaces support IGMP.
3. Run:
igmp require-router-alert
The S7700 is configured to ignore the IGMP messages that do not contain the Router-
Alert option.
4. Run:
igmp send-router-alert
The S7700 is configured to add the Router-Alert option to the IGMP message header.
NOTE
After you run the igmp send-router-alert command, information about the Router-Alert
option will not be displayed when you view the current configuration. To view information
about the Router-Alert option, run the undo igmp send-router-alert command first.
----End
4.4.3 Configuring the IGMPv1 Querier
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 4 IGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
77