The VLAN view is displayed.
Step 3 Run:
mld-snooping router-aging-time router-aging-time
The aging time of the router interface is set.
l By default, the S7700 sets the remaining aging time of router interface as follows:
l If the router interface receives an MLD Query message, the S7700 sets the remaining aging
time of the interface to 180 seconds.
l If the router interface receives a PIM Hello message and the holdtime value of the Hello
message is greater than the remaining aging time of the interface, the S7700 sets the remaining
aging time of the interface to the holdtime value.
----End
11.7.3 (Optional) Setting Parameters Related to the Aging Time of
Member Interfaces
Context
To set the parameters related to the aging time of member interfaces, perform the following steps
at a random order.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Step 3 Run:
mld-snooping query-interval query-interval
The interval for sending the General Query messages is set. The default value is 60 seconds.
Step 4 Run:
mld-snooping max-response-time max-response-time
The maximum response time of MLD messages is set. The default value is 10 seconds.
Step 5 Run:
mld-snooping robust-count robust-count
The robustness variable of MLD is set. The default value is 2.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
400
To Next Page
Loading...
