Huawei quidway s7700 - Monitoring the Running Status of PIM-SM

Procedure
Step 1 After confirming that PIM status of the specified downstream interfaces of the specified PIM
entry need to be cleared, run the reset pim [ vpn-instance vpn-instance-name ] routing-table
group group-address mask { group-mask-length | group-mask } source source-address
interface interface-type interface-number command in the user view.
----End
6.15.3 Monitoring the Running Status of PIM-SM
During the routine maintenance, you can run the display commands in any view to know the
running of PIM.
Context
In routine maintenance, you can run the following commands in any view to check the running
status of PIM-SM.
Procedure
l Run the display pim [ vpn-instance vpn-instance-name | all-instance ] claimed-route
[ source-address ] command in any view to check the unicast routes used by PIM.
l Run the display pim [ vpn-instance vpn-instance-name | all-instance ] bfd session
[ interface interface-type interface-number | neighbor neighbor-address ]
*
command in
any view to check information about a PIM BFD session.
l Run the display pim [ vpn-instance vpn-instance-name | all-instance ] bsr-info command
in any view to check information about the BSR in a PIM-SM domain.
l Run the display pim [ vpn-instance vpn-instance-name | all-instance ] control-message
counters [ message-type { assert | graft | graft-ack | hello | join-prune | state-refresh |
bsr } | interface interface-type interface-number ]
*
command in any view to check the
number of sent or received PIM control messages.
l Run the display pim [ vpn-instance vpn-instance-name | all-instance ] interface
[ interface-type interface-number | up | down ] [ verbose ] command in any view to check
PIM on an interface.
l Run the command display pim [ vpn-instance vpn-instance-name | all-instance ]
neighbor [ neighbor-address | interface interface-type interface-number | verbose ]
*
to
check PIM neighbors.
l Run the following commands in any view to check the PIM routing table.
– display pim { vpn-instance vpn-instance-name | all-instance } routing-table [ group-
address [ mask { group-mask-length | group-mask } ] | source-address [ mask { source-
mask-length | source-mask } ] | incoming-interface { interface-type interface-
number | register } | outgoing-interface { include | exclude | match } { interface-type
interface-number | register | none } | mode { dm | sm | ssm } | flags flag-value | fsm ]
*
[ outgoing-interface-number [ number ] ]
– display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-
interface { interface-type interface-number | register } | outgoing-interface
{ include | exclude | match } { interface-type interface-number | vpn-instance vpn-
instance-name | register | none } | mode { dm | sm | ssm } | flags flag-value | fsm ]
*
[ outgoing-interface-number [ number ] ]
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 6 PIM-SM (IPv4) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
194