– display pim routing-table [ group-address [ mask { group-mask-length | group-
mask } ] | source-address [ mask { source-mask-length | source-mask } ] | incoming-
interface { interface-type interface-number | register } | outgoing-interface
{ include | exclude | match } { interface-type interface-number | vpn-instance vpn-
instance-name | register | none } | mode { dm | sm | ssm } | flags flag-value | fsm ]
*
[ outgoing-interface-number [ number ] ]
– display pim [ vpn-instance vpn-instance-name | all-instance ] routing-table brief
[ group-address [ mask { group-mask-length | group-mask } ] | source-address
[ mask { source-mask-length | source-mask } ] | incoming-interface { interface-type
interface-number | register } ]
*
----End
Example
Run the display pim interface verbose command, and you can view the detailed information
about PIM on the interface in the public network instance.
<Quidway> display pim interface verbose
VPN-Instance: public net
Interface: Vlanif117, -
PIM version: 2
PIM mode: Dense
PIM state: down
PIM DR: -
PIM DR Priority (configured): 1
PIM neighbor count: -
PIM hello interval: 30 s
PIM LAN delay (negotiated): -
PIM LAN delay (configured): 500 ms
PIM hello override interval (negotiated): -
PIM hello override interval (configured): 2500 ms
PIM Silent: disabled
PIM neighbor tracking (negotiated): -
PIM neighbor tracking (configured): disabled
PIM generation ID: -
PIM require-GenID: disabled
PIM hello hold interval: 105 s
PIM assert hold interval: 180 s
PIM triggered hello delay: 5 s
PIM J/P interval: 60 s
PIM J/P hold interval: 210 s
PIM state-refresh processing: enabled
PIM state-refresh interval: 60 s
PIM graft retry interval: 3 s
PIM state-refresh capability on link: capable
PIM BFD: disabled
PIM dr-switch-delay timer : not configured
Number of routers on link not using DR priority: -
Number of routers on link not using LAN delay: -
Number of routers on link not using neighbor tracking: -
ACL of PIM neighbor policy: -
ACL of PIM ASM join policy: -
ACL of PIM SSM join policy: -
5.4 Adjusting Control Parameters of a Multicast Source
A multicast device can control the forwarding of multicast data based on multicast sources. This
helps to control multicast data flows and limit information that can be obtained by downstream
receivers to enhance security.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 5 PIM-DM (IPv4) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
111
To Next Page
Loading...
