Huawei quidway s7700 - Creating a Multicast VLAN; Binding User Vlans to a Multicast VLAN on an Interface

No. Data
3 Types and numbers of interfaces
3.4.2 Creating a Multicast VLAN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
Step 3 Run:
igmp-snooping enable
IGMP snooping is enabled in the VLAN.
----End
3.4.3 Binding User VLANs to a Multicast VLAN on an Interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
l2-multicast-bind vlan vlanid1 [ to vlanid2 ] mvlan mvlanid
User VLANs are bound to a multicast VLAN on the interface.
This command is used on user-side interfaces.
NOTE
After a user VLAN is bound to a multicast VLAN on an interface, Layer 2 multicast call admission control
(CAC) based on the interface and Layer 2 multicast CAC based on the interface and user VLAN do not
take effect on the interface. However, you can configure Layer 2 multicast CAC based on the interface and
a non-user VLAN.
The user VLANs must exist, and cannot be multicast VLANs or user VLANs of another multicast VLAN.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 3 Multicast VLAN Replication Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
60