Huawei quidway s7700 - Configuring Prompt Leave of Interfaces; Establishing the Configuration Task

Procedure
Step 1 Run the display mld-snooping [ vlan vlan-id ] [ configuration ] command to check the
configuration of MLD snooping in a VLAN.
Step 2 Run the display mld-snooping port-info [ vlan vlan-id [ group group-ipv6-address [ source-
address source-ipv6-address ] | verbose ] ] command to check the configuration of MLD
snooping on an interface.
----End
11.5 Configuring Prompt Leave of Interfaces
This section describes how to configure prompt leave of interfaces in a VLAN.
11.5.1 Establishing the Configuration Task
Applicable Environment
If each interface in a VLAN is connected to only one multicast receiver, you can enable prompt
leave on the interfaces to save bandwidth.
Pre-configuration Tasks
Before configuring the prompt leave function for interfaces in a VLAN, complete the following
tasks:
l 11.3 Enabling MLD Snooping
l Creating an ACL6
Data Preparation
To configure the prompt leave function for interfaces in a VLAN, you need the following data.
No.
Data
1 ID of the VLAN where the prompt leave
function needs to be configured
11.5.2 Configuring Prompt Leave of Interfaces
Context
To configure the prompt leave function in a VLAN, do as follows on the S7700.
Procedure
Step 1 Run:
system-view
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
394