The rules for filtering Register messages are set.
The RP accepts or rejects to a Register message according to the rules.
----End
13.7.3 Configuring PIM-SM (IPv6) Registering Suppression
You can set the timeout period for keeping the register suppression state and the interval for
sending null Register messages on all the devices that may become DRs at the multicast source
side.
Context
Do as follows on the switch that may become the DR at the source side:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
register-suppression-timeout interval
The timeout period for keeping the suppressed state of the registering is set.
Step 4 Run:
probe-interval interval
The interval for sending null Register messages is set.
----End
13.7.4 Checking the Configuration
After control parameters for source registering are adjusted, you can run the corresponding
command to check information about the PIM interface.
Procedure
l Run the display pim ipv6 interface [ interface-type interface-number | up | down ]
[ verbose ] command to check information about PIM-IPv6 interfaces.
----End
13.8 Adjusting Control Parameters for Forwarding
A multicast device sends Join messages upstream to require forwarding multicast data and Prune
messages to require stopping the forwarding of multicast data. You can adjust control parameters
for multicast data forwarding as required. If there is no special requirement, adopt default values.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 13 PIM-SM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
477
To Next Page
Loading...
