Huawei quidway s7700 - Example for Configuring SSM Mapping

ip address 192.168.2.1 255.255.255.0
pim sm
#
interface gigabitethernet 1/0/0
port hybrid pvid vlan 20
port hybrid untagged vlan 20
#
interface gigabitethernet 2/0/0
port hybrid pvid vlan 21
port hybrid untagged vlan 21
#
ospf 1
area 0.0.0.0
network 10.110.2.0 0.0.0.255
network 192.168.2.0 0.0.0.255
#
return
l Configuration file of SwitchC
#
sysname SwitchC
#
vlan batch 30 31
#
multicast routing-enable
#
interface Vlanif30
ip address 10.110.2.2 255.255.255.0
pim sm
igmp enable
#
interface Vlanif31
ip address 192.168.3.1 255.255.255.0
pim sm
#
interface gigabitethernet 1/0/0
port hybrid pvid vlan 30
port hybrid untagged vlan 30
#
interface gigabitethernet 2/0/0
port hybrid pvid vlan 31
port hybrid untagged vlan 31
#
ospf 1
area 0.0.0.0
network 10.110.2.0 0.0.0.255
network 192.168.3.0 0.0.0.255
#
return
4.8.2 Example for Configuring SSM Mapping
Networking Requirements
On the multicast network as shown in Figure 4-2, PIM-SM is run and ASM and SSM models
are used to provide multicast services. IGMPv3 is run on the interface on the Switch connected
to the Receiver. The IGMP version on the Receiver is IGMPv2 and cannot be upgraded to
IGMPv3.
The range of SSM group addresses on the current network is 232.1.1.0/24. S1, S2, and S3 send
multicast data to the multicast group whose IP address is in this range. The Receiver receives
the multicast data only from S1 and S3.
Solution: Configure SSM mapping on SwitchD.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 4 IGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
93