Huawei quidway s7700 - Checking the Configuration

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The VLANIF interface view is displayed.
Step 3 Run:
pim ipv6 dm
Basic PIM-DM (IPv6) functions are enabled.
After PIM-DM (IPv6) is enabled on interfaces, switchs set up the PIM-IPv6 neighbor
relationship with each other. The switchs can then process protocol packets received from PIM-
IPv6 neighbors.
You can run the undo pim ipv6 dm command to disable PIM-DM (IPv6) on an interface.
NOTE
PIM-DM (IPv6) and PIM-SM (IPv6) cannot be enabled on an interface simultaneously. The PIM-IPv6
modes on all interfaces that belong to the same instance must be the same. When a switch is deployed in
a PIM-DM (IPv6) domain, enable PIM-DM (IPv6) on all non-boundary interfaces.
----End
12.3.4 Checking the Configuration
After IPv6 PIM-DM is configured successfully, you can check information about the PIM
interface, PIM neighbor, and PIM routing table through commands..
Procedure
l Run the display pim ipv6 interface [ interface-type interface-number | up | down ]
[ verbose ] command to check information about PIM-IPv6 interfaces.
l Run the display pim ipv6 neighbor [ ipv6-link-local-address | interface interface-type
interface-number | verbose ]
*
command to check information about PIM-IPv6 neighbors.
l Run the following commands to check the PIM-IPv6 multicast routing table.
– display pim ipv6 routing-table [ ipv6-source-address [ mask mask-length ] | ipv6-
group-address [ mask mask-length ] | flags { act | del | exprune | ext | loc | niif |
nonbr | none | rpt | sg_rcvr | sgjoin | spt | swt | wc | upchg } | fsm | incoming-
interface { interface-type interface-number | register } | mode { dm | sm | ssm } |
outgoing-interface { exclude | include | match } { interface-type interface-number |
none | register } ]
*
[ outgoing-interface-number [ number ] ]
– display pim ipv6 routing-table brief [ ipv6-source-address [ mask mask-length ] |
ipv6-group-address [ mask mask-length ] | incoming-interface { interface-type
interface-number | register } ]
*
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 12 PIM-DM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
420