Huawei quidway s7700 - Configuring Static RPF Peers

l text: specifies the description text. The text is a string of 80 characters.
----End
7.3.4 Configuring Static RPF Peers
You can configure a static RPF peer relationship between RPs in different ASs so that PIM-SM
domains in different ASs can share multicast source information.
Context
NOTE
If Configuring Inter-AS MSDP Peers on MBGP Peers is complete, skip the configuration.
Do as follows on two RPs of different ASs:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
msdp [ vpn-instance vpn-instance-name ]
MSDP is enabled in the public network instance or VPN instance, and the MSDP view is
displayed.
Step 3 Run:
peer peer-address connect-interface interface-type interface-number
An MSDP peer connection is configured.
The parameters of the command are explained as follows:
l peer-address: specifies the address of a remote MSDP peer.
l interface-type interface-number: specifies the local interface connected to the remote MSDP
peer.
Step 4 (Optional) Run:
peer peer-address description text
The description of a remote MSDP peer is added.
The configuration helps to distinguish remote MSDP peers and manage the connections with
the remote MSDP peers.
The parameters of the command are explained as follows:
l peer-address: specifies the address of a remote MSDP peer.
l text: specifies the description text. The text is a string of up to 80 characters.
Step 5 Run:
static-rpf-peer peer-address [ rp-policy ip-prefix-name ]
A remote MSDP peer is statically specified as an RPF peer.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 7 MSDP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
230