Huawei quidway s7700 - Configuring an MSDP Peer

Do as follows on all switchs in the PIM-SM domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim [ vpn-instance vpn-instance-name ]
The PIM view is displayed.
Step 3 Run:
static-rp rp-address
The loopback interface address is configured as a static RP address.
----End
7.4.5 Configuring an MSDP Peer
MSDP peer relationships need be set up between RPs. If there are more than three devices,
MSDP peer relationships should be set up between any two devices and all MSDP peers should
be added to one mesh group.
Context
Do as follows on multiple switchs on which an anycast RP is to be created:
NOTE
If the number of switchs configured with the RPs that have the same IP address exceeds two, ensure the
interconnection between the switchs that set up MSDP peer relationship.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
msdp [ vpn-instance vpn-instance-name ]
MSDP is enabled in the public network instance or the VPN instance, and the MSDP view is
displayed.
Step 3 Run:
peer peer-address connect-interface interface-type interface-number
An MSDP peer connection is created.
The parameters of the command are explained as follows:
l peer-address: specifies the address of a remote MSDP peer.
l interface-type interface-number: specifies the local interface.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 7 MSDP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
235