Huawei quidway s7700 - Configuring a Static Multicast MAC Address

No. Data
1 Number of the interface to be configured with
a static multicast MAC address
2 ID of the VLAN that the interface belongs to
2.5.2 Configuring a Static Multicast MAC Address
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Configure a static multicast MAC address:
l Configure a static multicast MAC address on an interface:
1. Run:
interface interface-type interface-number
The interface view is displayed.
The interface type can be Ethernet, GE, XGE, or Eth-Trunk.
2. Run:
mac-address multicast mac-address vlan vlan-id
A static multicast MAC address is configured on the interface.
l Configure a static multicast MAC address on multiple interfaces:
Run:
mac-address multicast mac-address interface { interface-type interface-number1
[ to interface-type interface-number2 ] } &<1–10> vlan vlan-id
The static multicast MAC address is configured on multiple interfaces.
The interface numbers must be consecutive; the specified interfaces must be on the same
board; interface-number2 must be greater than interface-number1.
After a static multicast MAC address is configured on interfaces, multicast packets destined for
the multicast MAC address are forwarded only to the interfaces.
Note the following points when configuring a static multicast MAC address:
l The specified VLAN exists and the interfaces have been added to the VLAN.
l The value of mac-address must be a multicast MAC address, which starts with 01.
l The MAC address cannot be in the range from 0100-5E00-0000 to 0100-5E00-7FFF (used
for IPv4 multicast) or 3333-xxxx-xxxx (used for IPv6 multicast).
l The VLAN cannot be a super-VLAN, a leased line VLAN, or the control VLAN of a Smart
Ethernet Protocol (SEP) segment or Rapid Ring Protection Protocol (RRPP) ring.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 2 IGMP Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
30