Huawei quidway s7700 - Adjusting Control Parameters of a C-RP

Pre-configuration Tasks
Before adjusting control parameters of a C-RP and a C-BSR, complete the following tasks:
l Configuring a unicast routing protocol
l Configuring Basic PIM-SM (IPv6) Functions
Data Preparation
To adjust control parameters of a C-RP and C-BSR, you need the following data.
No. Data
1 Priority of the C-RP
2 Interval during which the C-RP sending advertisement messages
3 Timeout period during which the BSR waits to receive the advertisement message
from the C-RP
4 Hash mask length of the C-BSR
5 Priority of the C-BSR
6 Interval during which the C-BSR sends Bootstrap messages
7 Period for keeping the Boostrap message received from the BSR
8 ACL6 that defines the legal BSR address range
9 ACL6 that defines the legal C-RP address range
13.5.2 Adjusting Control Parameters of a C-RP
C-RPs periodically send Advertisement messages to a BSR. The Advertisement messages carry
C-RP priorities. You can adjust the C-RP priority, the interval for sending Advertisement
messages, and the holdtime of Advertisement messages on a device configured with the C-RP.
Context
Do as follows on the switch on which the C-RP is configured:
NOTE
Do as follows on the switch that has been configured with a C-RP. This configuration is optional. If there
is no special requirement, default values are recommended.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 13 PIM-SM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
465