Huawei quidway s7700 - Optional) Configuring an Embedded-RP

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The VLANIF interface view is displayed.
Step 3 Run:
pim ipv6 sm
PIM-SM (IPv6) is enabled.
After PIM-SM (IPv6) is enabled on interfaces, switchs set up PIM-IPv6 neighbor relationship
with each other. The switchs can then process protocol packets received from PIM-IPv6
neighbors.
You can run the undo pim ipv6 sm command to disable PIM-SM (IPv6) on an interface.
NOTE
PIM-DM (IPv6) and PIM-SM (IPv6) cannot be enabled on an interface simultaneously. The PIM mode on
all interfaces that belong to the same instance must be the same. When a switch is deployed in a PIM-SM
(IPv6) domain, enable PIM-SM (IPv6) on all non-boundary interfaces.
----End
13.3.4 (Optional) Configuring an Embedded-RP
IPv6 PIM-SM supports the embedded-RP and the range of multicast groups that the embedded-
RP serves set on all devices must be the same.
Context
Do as follows on all switchs in the PIM-SM (IPv6) domain:
NOTE
This configuration is optional. By default, the embedded-RP is enabled. The group address range of the
embedded-RP is FF7x::/12, and the value of x ranges from 0, 3 to F.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
embedded-rp [ basic-acl6-number | acl6-name acl6-name ]
The group address range of an embedded-RP is specified.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 13 PIM-SM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
457