Huawei quidway s7700 - Configuring Channels on a VLAN

2.6.4 Configuring Channels on a VLAN
Context
Do as follows on the UPE.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 (Optional) Configure the global channels.
1. Run:
l2-multicast-channel
The global channel view is displayed.
2. Run:
channel channel-name [ type [ asm | ssm ] ]
A global channel is configured and the channel view is displayed.
3. Run:
group group-address { group-mask-length | group-mask }
The multicast group member in the global channel is configured.
Step 3 Run:
quit
Return to the system view.
Step 4 Run:
l2-multicast-channel vlan vlan-id
The VLAN channel view is displayed.
The VLAN specified in this command must be a VLAN that is not bound to a VSI and must not
be a user VLAN or a protection VLAN. Otherwise, the channel cannot be configured.
Step 5 Run:
channel channel-name
The channel name is created.
The name of a VLAN channel must be different from the name of a global channel.
Step 6 Run:
group group-address { group-mask-length | group-mask }
The multicast group member in the channel is configured.
The specified group address must be different from the group addresses specified for other
channels in this VLAN or the group address of the global channel.
Step 7 Run:
quit
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 2 IGMP Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
35