Huawei quidway s7700 - Optional) Configuring Multicast Policies

Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Step 3 Run:
igmp-snooping querier enable
The IGMP snooping querier is enabled for the VLAN.
By default, an IGMP snooping querier is disabled.
Step 4 (Optional) Run:
igmp-snooping query-interval query-interval
The interval at which the querier sends IGMP General Query messages is set.
By default, the interval for sending IGMP General Query messages is 60 seconds.
Step 5 (Optional) Run:
igmp-snooping robust-count robust-count
The robustness variable of the querier is set.
By default, the robustness variable is 2.
Step 6 (Optional) Run:
igmp-snooping lastmember-queryinterval lastmember-queryinterval
The interval at which the querier sends Last Member Query messages is set.
By default, the interval for sending Last Member Query messages is 1 second.
----End
2.3.8 (Optional) Configuring Multicast Policies
Context
A multicast group policy in a VLAN is used to add the hosts in the VLAN to the specified
multicast groups and limit the number of multicast groups that a host can join.
NOTE
When you create an ACL for a multicast group policy of a VLAN, the configuration takes effect only if
you select deny in the rule command. That is, a multicast group policy can only prohibit hosts in a VLAN
from accessing all or specified multicast groups.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 2 IGMP Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
18