Huawei quidway s7700 - Limiting the Number of Multicast Groups in a Channel for a VLAN, an Interface, or an Interface in a VLAN

The Ethernet, GigabitEthernet, or Eth-Trunk interface view is displayed.
Step 5 Run:
l2-multicast limit max-entry count [ except acl-number ]
Limitation on the number of multicast groups on a Layer 2 interface is configured.
Step 6 Run:
l2-multicast limit max-entry count [ vlan { { vlan-id [ to vlan-id ] } &<1-10> } ]
[ except acl-number ]
Limitation on the number of multicast groups on an interface of a VLAN is configured.
NOTE
The interface-based Layer 2 multicast CAC is applicable to only the multicast VLAN, but not applicable
to user VLANs.
The except acl-number parameters exclude the multicast groups that are not limited. The parameters have
the same function in other configuration commands.
----End
2.6.3 Limiting the Number of Multicast Groups in a Channel for a
VLAN, an Interface, or an Interface in a VLAN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
l2-multicast limit channel channel-name { max-entry count } [ vlan { { vlan-id
[ to vlan-id ] } &<1-10> } ]
Limitation on the number of multicast groups in a channel is configured for the entire system or
a VLAN.
Step 3 Run:
interface interface-type interface-number
The Ethernet, GigabitEthernet, or Eth-Trunk interface view is displayed.
Step 4 Run:
l2-multicast limit channel channel-name { max-entry count }
Limitation on the number of multicast groups in a channel is configured on the interface.
Step 5 Run:
l2-multicast limit channel channel-name { max-entry count } [ vlan { { vlan-id
[ to vlan-id ] } &<1-10> } ]
Limitation on the number of multicast groups in a channel is configured for the interface in a
specified VLAN.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 2 IGMP Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34