Huawei quidway s7700 - Example for Connecting RPF Routes through Static Multicast Routes

port hybrid untagged vlan 30
#
ospf 1
area 0.0.0.0
network 12.1.1.0 0.0.0.255
network 13.1.1.0 0.0.0.255
#
return
9.8.2 Example for Connecting RPF Routes Through Static Multicast
Routes
Networking Requirements
As shown in Figure 9-2, PIM-DM runs on the network and all Switch support multicast. The
receiver can receive information from the multicast source Source1. Switch B and Switch C run
OSPF. No unicast route is available between Switch A and Switch B. You need to use a multicast
static route to enable the receiver to receive information sent by Source2.
Figure 9-2 Networking diagram for connecting the RPF route through static multicast routes
SwitchA
GE1/0/0
Source2
10.1.5.2/24
Source1
SwitchC
SwitchB
GE1/0/0
GE1/0/0
GE3/0/0
GE2/0/0
OSPF
Receiver
Multicast static route
GE3/0/0
GE2/0/0
PIM-DM
10.1.3.2/24
Switch
Physical interface VLANIF interface IP address
Switch A GE 1/0/0 VLANIF 11 10.1.5.1/24
GE 3/0/0 VLANIF 40 10.1.4.2/24
Switch B GE 1/0/0 VLANIF 20 10.1.2.2/24
GE 2/0/0 VLANIF 13 10.1.3.1/24
GE 3/0/0 VLANIF 40 10.1.4.1/24
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 9 IPv4 Multicast Routing Management
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
343