The interface can be an Ethernet interface, a GE interface, an XGE interface, or an Eth-Trunk
interface.
Step 3 Run:
port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
The interface is added to VLANs.
NOTE
If multicast VLAN replication is not configured, the interface of the S7700 that connects to a router and
receives the multicast packets from the router and the interface that connects to users and sends multicast
packets to users must be added to the same VLAN.
----End
2.4.5 Adding an Interface to a Multicast Group Statically
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be an Ethernet interface, a GE interface, an XGE interface, or an Eth-Trunk
interface.
Step 3 Run:
l2-multicast static-group [ source-address source-ip-address ] group-address group-
ip-address vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>
The interface is added to the multicast group statically. You can also run the l2-multicast static-
group [ source-address source-ip-address ] group-address group-ip-address1 to group-ip-
address2 vlan vlan-id command to join the interface to the group-address in batches.
After an interface is added to a multicast group statically, multicast protocol packets are not
forwarded to the router interface.
----End
2.4.6 Checking the Configuration
Prerequisite
The configuration of static Layer 2 multicast for a VLAN is complete.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 2 IGMP Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
28
To Next Page
Loading...
