3.4.4 Adding Interfaces to VLANs
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Add a network-side interface to a multicast VLAN.
1. Run the interface interface-type interface-number command to enter the network-side
interface view.
2. Configure the network-side interface as a trunk or hybrid interface and add the interface to
the multicast VLAN. For the configuration procedure, see Dividing a LAN into VLANs
Based on Ports.
3. Run the quit command to return to the system view.
Step 3 Add a user-side interface to a user VLAN.
1. Run the interface interface-type interface-number command to enter the user-side interface
view
2. Configure the user-side interface as a trunk or hybrid interface and add the interface to the
user VLAN. For the configuration procedure, see Dividing a LAN into VLANs Based on
Ports.
----End
3.4.5 Checking the Configuration
Procedure
l Run the display l2-multicast-bind [ mvlan vlan-id ] command to view information about
a multicast VLAN and user VLANs bound to the multicast VLAN on an interface.
----End
Example
Run the display l2-multicast-bind [ mvlan vlan-id ] command to view information about a
multicast VLAN and its user VLANs.
<Quidway> display l2–multicast-bind mvlan 90
Port Startvlan Endvlan Mvlan
------------------------------------------------------------------
GigabitEthernet1/0/9 901 -- 90
Total Table(s) : 1
3.5 Configuration Examples
This section provides configuration examples of multicast VLAN replication.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 3 Multicast VLAN Replication Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
61
To Next Page
Loading...
