Number of routers on link not using DR priority: -
Number of routers on link not using LAN delay: -
Number of routers on link not using neighbor tracking: -
ACL of PIM neighbor policy: -
ACL of PIM ASM join policy: -
ACL of PIM SSM join policy: -
5.11 Maintaining PIM-DM (IPv4)
Maintaining PIM-DM involves resetting PIM statistics, and monitoring PIM running status.
5.11.1 Clearing Statistics of PIM Control Messages
If you need to re-collect the statistics about PIM control messages, you can reset the existent
statistics. Note that the statistics cannot be restored after you reset them. This operation does not
affect normal running of PIM.
Context
CAUTION
The statistics of the PIM control messages on the interface cannot be restored after you reset
them. Confirm the action before you run the command.
Procedure
l Run the reset pim [ vpn-instance vpn-instance-name | all-instance ] control-message
counters [ interface interface-type interface-number ] command in the user view to clear
the statistics of the PIM control messages on an interface.
----End
5.11.2 Monitoring the Running Status of PIM
During the routine maintenance, you can run the display commands in any view to know the
running of PIM.
Context
In routine maintenance, you can run the following commands in any view to check the running
status of PIM.
Procedure
l Run the display pim [ vpn-instance vpn-instance-name | all-instance ] claimed-route
[ source-address ] command in any view to check the unicast routes used by PIM.
l Run the display pim [ vpn-instance vpn-instance-name | all-instance ] control-message
counters [ message-type { assert | graft | graft-ack | hello | join-prune | state-refresh |
bsr } | interface interface-type interface-number ]
*
command in any view to check the
number of sent or received PIM control messages.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 5 PIM-DM (IPv4) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
135
To Next Page
Loading...
