Huawei quidway s7700 - Maintaining MLD Snooping; Clearing MLD Snooping Entries

Procedure
Step 1 Run the display mld-snooping [ vlan vlan-id ] command to check information about MLD
snooping in a VLAN.
----End
Example
If the preceding configurations are successful, the following information is displayed:
<Quidway> display mld-snooping vlan 10
MLD Snooping Vlan Information for VLAN 10
MLD Snooping is Enable
MLD Version is Set to default 1
MLD Query Interval is Set to default 125
MLD Max Response Interval is Set to default 10
MLD Robustness is Set to default 2
MLD Last Member Query Interval is Set to default 1
MLD Router Port Aging Interval is Set to 180s or holdtime in hello
MLD Filter Group-Policy is Set to default : Permit All
MLD Prompt Leave Disable
MLD Router Alert is Not Required
MLD Send Router Alert Enable
MLD Snooping Querier Disable
11.8 Maintaining MLD Snooping
This section describes how to maintain MLD snooping.
11.8.1 Clearing MLD Snooping Entries
Context
CAUTION
Use this command with caution. After the MLD snooping entries, that is, the dynamic forwarding
entries, of a VLAN are deleted from the multicast forwarding table, the multicast flows sent to
hosts in the VLAN are interrupted. The hosts can receive multicast flows again only after the
S7700 receives the MLD Membership Report messages from the hosts and generates new
forwarding entries.
To clear the dynamic forwarding entries from the multicast forwarding table, run the following
command in the user view.
Procedure
Step 1 Run the reset mld-snooping group { vlan { vlan-id | all } | all } command to clear the dynamic
forwarding entries from the multicast forwarding table.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
403