Huawei quidway s7700 - Enabling MLD Snooping in a VLAN; Optional) Adding an Interface to a Multicast Group Statically

11.3.3 Enabling MLD Snooping in a VLAN
Context
To enable MLD snooping in a VLAN, do as follows on the S7700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Step 3 Run:
mld-snooping enable
MLD snooping is enabled in the VLAN.
When MLD snooping is disabled in a VLAN by default.
----End
11.3.4 (Optional) Adding an Interface to a Multicast Group
Statically
Context
To add an interface to a multicast group statically, do as follows on the S7700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the following commands as required:
l Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be an Ethernet interface, a GE interface, an XGE interface, or an Eth-Trunk
interface.
Step 3 Run:
mld-snooping static-group { group-ipv6-address [ source source-ipv6-address ]
vlan vlan-id }
The interface is added to a multicast group statically.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
390