Huawei quidway s7700 - Enabling Ipv6 Multicast Routing; Enabling MLD

Data Preparation
To configure basic MLD functions, you need the following data.
No. Data
1 MLD version
2 Group address and source address
3 ACL6 rules for filtering multicast groups
10.3.2 Enabling IPv6 Multicast Routing
Before configuring basic MLD functions, enable IPv6 multicast routing.
Context
Do as follows on the switch connected to hosts:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
multicast ipv6 routing-enable
IPv6 multicast routing is enabled in the public network instance.
----End
10.3.3 Enabling MLD
After MLD is enabled on an interface of a multicast device connected with the user network
segment, user hosts can dynamically join multicast groups.
Context
Do as follows on the switch connected to hosts:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 10 MLD Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
359