Huawei quidway s7700 - Optional) Configuring the Interval for Checking the Forwarding Rate of Multicast Data

Context
Do as follows on the switch that may become the DR at the receiver side:
NOTE
This configuration is optional. By default, the RP and the DR at the receiver side immediately perform the
SPT switchover after receiving the first multicast data packet.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
spt-switch-threshold { traffic-rate | infinity } [ group-policy { basic-acl6-
number | acl6-name acl6-name } [ order order-value ] ]
Conditions of the SPT switchover are adjusted.
The parameters of this command are explained as follows:
l traffic-rate: specifies the rate threshold of SPT switchover.
l infinity: indicates that the SPT switchover is not triggered.
l group-policy { basic-acl6-number | acl6-name acl6-name } [ order order-value ]: specifies
the range of the multicast groups that use the threshold. By default, the threshold is applicable
to all multicast groups.
----End
13.10.3 (Optional) Configuring the Interval for Checking the
Forwarding Rate of Multicast Data
After conditions for the SPT switchover are configured, you can set the interval for checking
the forwarding rate of multicast data.
Context
Do as follows on the switch that may become the DR at the receiver side:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 13 PIM-SM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
487