Procedure
l Run the debugging pim [ vpn-instance vpn-instance-name | all-instance ] all command
in the user view to enable all the debugging of PIM.
l Run the debugging pim [ vpn-instance vpn-instance-name | all-instance ] event
[ advanced-acl-number ] command in the user view to enable the debugging of PIM events.
l Run the debugging pim [ vpn-instance vpn-instance-name | all-instance ] routing-
table [ advanced-acl-number ] command in the user view to enable the debugging of PIM
routes.
l Run the debugging pim [ vpn-instance vpn-instance-name | all-instance ] neighbor
[ basic-acl-number | [ receive | send ] ]
*
command in the user view to enable the debugging
of PIM neighbors.
l Run the debugging pim [ vpn-instance vpn-instance-name | all-instance ] assert
[ advanced-acl-number | [ receive | send ] ]
*
command in the user view to enable the
debugging of PIM Assert.
l Run the debugging pim [ vpn-instance vpn-instance-name | all-instance ] join-prune
[ advanced-acl-number | [ receive | send ] ]
*
command in the user view to enable the
debugging of PIM Join/Prune.
l Run the debugging pim [ vpn-instance vpn-instance-name | all-instance ] state-refresh
[ advanced-acl-number | [ receive | send ] ]
*
command in the user view to enable the
debugging of PIM State-Refresh.
----End
5.12 Configuration Example
Configuration examples are provided to show how to construct a basic PIM-DM network.
5.12.1 Example for Configuring the PIM-DM Network
Networking Requirements
On the experiment network shown in Figure 5-2, multicast is deployed. The unicast routes work
normally. The Switches on the network need to be configured properly so that hosts can receive
the VOD information in multicast mode.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 5 PIM-DM (IPv4) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
137
To Next Page
Loading...
