The vlan-id1 and vlan-id2 parameters specify user VLAN IDs. The value of vlan-id2 must be
greater than the value of vlan-id1.
NOTE
The user VLANs specified in the command must be existing VLANs enabled with IGMP snooping and
cannot be multicast VLANs or user VLANs of another multicast VLAN.
----End
3.3.3 Adding Interfaces to VLANs
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Add a network-side interface to a multicast VLAN.
1. Run the interface interface-type interface-number command to enter the network-side
interface view.
2. Configure the network-side interface as a trunk or hybrid interface and add the interface to
the multicast VLAN. For the configuration procedure, see Dividing a LAN into VLANs
Based on Ports.
3. Run the quit command to return to the system view.
Step 3 Add a user-side interface to a user VLAN.
1. Run the interface interface-type interface-number command to enter the user-side interface
view
2. Configure the user-side interface as a trunk or hybrid interface and add the interface to the
user VLAN. For the configuration procedure, see Dividing a LAN into VLANs Based on
Ports.
----End
3.3.4 Checking the Configuration
Prerequisite
The configuration of multicast VLAN replication is complete.
Procedure
l Run the display multicast-vlan vlan [ vlan-id ] command to view information about a
multicast VLAN.
----End
Example
Run the display multicast-vlan vlan [ vlan-id ] command to view information about a multicast
VLAN.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 3 Multicast VLAN Replication Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
58
To Next Page
Loading...
