Huawei quidway s7700 - Configuring the Interval for Sending State-Refresh Messages; Configuring the Period for Receiving the Next State-Refresh Message

The interface on which PIM-DM State-Refresh is disabled cannot forward any State-Refresh
message.
NOTE
You can run the pim ipv6 state-refresh-capable command to re-enable the PIM-DM State-Refresh on the
interface.
----End
12.7.3 Configuring the Interval for Sending State-Refresh Messages
To prevent pruned interfaces from forwarding messages after the prune state timer times out,
you need to set the interval for sending State-Refresh messages to be shorter than the period for
keeping the Prune state.
Context
Do as follows on all switchs in the PIM-DM domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
state-refresh-interval interval
The interval for sending PIM-IPv6 State-Refresh messages is set.
NOTE
The interval for sending PIM State-Refresh messages should be shorter than the timeout period for keeping
the Prune state. You can run the holdtime join-prune command to set the timeout period for keeping the
Prune state.
----End
12.7.4 Configuring the Period for Receiving the Next State-Refresh
Message
A multicast device may receive PIM State-Refresh messages from multiple routers in a short
period and some PIM State-Refresh messages are repeated. Before the state-refresh timer times
out, the device discards the received repeated State-Refresh messages. The device is allowed to
receive the next State-Refresh message only after the timer times out.
Context
Do as follows on all switchs in the PIM-DM domain:
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 12 PIM-DM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
434