Huawei quidway s7700 - Enabling the MLD Snooping Querier

No. Data
1 Interval for sending MLD General Query
messages
2 Interval for sending MLD Group-Specific
Query messages
3 Maximum response time of the MLD General
Query message
4 Source IPv6 address of the MLD General
Query message
5 Source IPv6 address of the MLD Group-
Specific Query message
11.6.2 Enabling the MLD Snooping Querier
Context
Do as follows on the S7700.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
The VLAN view is displayed.
Step 3 Run:
mld-snooping querier enable
The MLD snooping querier is enabled.
NOTE
By default, the MLD snooping querier is disabled.
The MLD snooping querier does not participate in the election of the MLD querier; however, the MLD
snooping querier on an IPv6 multicast network running MLD may affect the election result because the
source IPv6 address of the Query message sent by the MLD snooping querier is small.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
396