Huawei quidway s7700 - Clearing the Statistics on MLD Snooping; Debugging MLD Snooping; Configuration Examples; Example for Configuring a Multicast Group Policy

11.8.2 Clearing the Statistics on MLD Snooping
Context
CAUTION
The statistics on MLD snooping cannot be restored after you clear them. So, confirm the action
before you use the command. To clear the statistics on MLD snooping, run the following
command in the user view.
Procedure
Step 1 Run the reset mld-snooping statistics [ vlan vlan-id ] command to clear the statistics on MLD
snooping in a VLAN.
----End
11.8.3 Debugging MLD Snooping
Context
CAUTION
Debugging affects the performance of the system. So, after debugging, run the undo debugging
mld-snooping all command to disable it immediately.
When a fault occurs in MLD Snooping, you can run the following debugging command in the
user view to debug MLD snooping and locate the fault.
Procedure
Step 1 Run the debugging mld-snooping [ all | event | done [ basic-acl-number ] | packet [advance-
acl-number ] | query [ advance-acl-number ] | report [ advance-acl-number ] | timer |
general ] command in the user view to enable debugging of MLD snooping.
----End
11.9 Configuration Examples
This section provides several configuration examples of MLD snooping.
11.9.1 Example for Configuring a Multicast Group Policy
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
404