Huawei quidway s7700 - Page 424

Networking Requirements
As shown in Figure 11-1, three hosts are all in VLAN 3. All these three hosts need to receive
data from multicast groups FF32::1 to FF32::10.
Figure 11-1 Networking diagram for configuring a multicast group policy on the Ethernet
multicast source
VLAN 3
Host 3 Host 4 Host 5
DHCP server
IP/MPLS core
GE1/0/5
GE1/0/6
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1. Create VLAN 3 and add GE 1/0/5 and GE 1/0/6 to VLAN 3.
2. Enable MLD snooping globally on SwitchA.
3. Configure a multicast group policy in VLAN 3 on SwitchA.
4. Enable MLD snooping in VLAN 3 on SwitchA.
Data Preparation
To complete the configuration, you need the following data:
l VLAN that Host 3, Host 4, and Host 5 belong to: VLAN 3
l Multicast groups that Host 3, Host 4, and Host 5 can join: FF32::1 to FF32::10
Procedure
Step 1 Create VLAN 3 on SwitchA and add GE 1/0/5 and GE 1/0/6 to VLAN 3. The configuration
procedure is not provided here.
Step 2 Enable MLD snooping globally on SwitchA.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 11 MLD Snooping Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
405