Huawei quidway s7700 - Disabling State-Refresh

Switchs under the control of default values can work normally. In the S7700, users can adjust
related parameters according to the specific network environment.
NOTE
If there is no special requirement, default values are recommended.
Pre-configuration Tasks
Before adjusting control parameters for State-Refresh, complete the following tasks:
l Configuring a unicast routing protocol
l Configuring Basic PIM-DM (IPv6) Functions
Data Preparation
To adjust control parameters for State-Refresh, you need the following data.
No. Data
1 Interval for sending PIM State-Refresh messages
2 Period for waiting to receive the next State-Refresh message
3 TTL value used to forward State-Refresh messages
12.7.2 Disabling State-Refresh
After this function is disabled on the interface, the interface cannot forward any State-Refresh
messages.
Context
Do as follows on all switchs in the PIM-DM domain:
NOTE
By default, PIM-DM State-Refresh is enabled on an interface.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
undo pim ipv6 state-refresh-capable
State-Refresh is disabled.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 12 PIM-DM (IPv6) Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
433