EasyManua.ls Logo

Huawei quidway s7700 - Checking the Configuration

Huawei quidway s7700
551 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Context
CAUTION
When configuring a static multicast route, configure the outgoing interface through the command
if the next hop is in the point-to-point format. If the next hop is not in the point-to-point format,
you must use the next hop.
Do as follows on the multicast switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip rpf-route-static [ vpn-instance vpn-instance-name ] source-address { mask | mask-
length } [ isis process-id | ospf process-id | rip process-id | bgp | static ]
[ route-policy route-policy-name ] { interface-type interface-number }
[ preference preference ] [ order order-number ]
A static multicast route is configured.
The parameters of the command are explained as follows:
l source-address { mask |mask-length }: specifies a source address and mask.
l isis process-id, ospf process-id, rip process-id, bgp, static: specifies that the matching route
must be present in the specified unicast routing protocol. protocol specifies a unicast routing
protocol. process-id specifies the ID of a process.
l route-policy policy-name: specifies the matching rule of the static multicast route.
l interface-type interface-number: specifies the type and the number of the outgoing interface.
The outgoing interface acts as the RPF interface.
l preference preference: specifies the preference of the route. The greater the preference value
is, the lower the preference is.
l order order-num: specifies the configuration order of routes on the same network segment.
----End
9.3.3 Checking the Configuration
After static multicast routes are configured, you can check the static multicast routing table and
RPF routing information to ensure the normal running of the multicast network.
Procedure
l Run the display multicast routing-table [ vpn-instance vpn-instance-name ] static
[ config ] [ source-address { mask | mask-length } ] command to check the static multicast
routing table.
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast 9 IPv4 Multicast Routing Management
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
324

Table of Contents

Other manuals for Huawei quidway s7700

Related product manuals